今日頭條
官方微信
官方抖音
案例頻道作者：陳中川，張冠宇（北京和利時智能技術有限公司，北京，100176）
摘要：本文以滴灌帶生產線打孔單元為研究對象，闡述了基本工藝流程以及打孔工藝的控制難點。基于和利時MC運動控制器給出系統設計方案，對控制算法設計進行說明。控制系統采用優化的飛剪算法實現打孔軸運動軌跡的實時規劃，達到自動糾偏的目的，保證系統穩定運行，避免頻發的故障停機。經測試，該控制系統滿足生產要求，運行穩定可靠，性能提升顯著。
關鍵詞：滴灌帶；打孔；飛剪；軌跡規劃
Abstract: Aiming at the drilling unit of drip irrigation belt production line,this paper introduces basic process and the control difficulties of the drilling control system. A control system based on Hollysys MC motion controller is proposed, and the control algorithm design is illustrated. The control system uses an optimized flying shear algorithm to realize the realtime planning of the movement trajectory of the punching shaft, achieving the goal of automatic deviation correction, ensuring the stable operation of the system, and avoiding frequent failures and shutdowns. The onsite test proved that the control system met production requirements, ran stably and reliably, and improved performance significantly.
Key words: Drip lrrigation belt; Drilling control system; Flying shear;Trajectory planning
在線預覽：基于飛剪實現軌跡規劃的滴灌帶打孔控制系統設計
摘自《自動化博覽》2020年3月刊
北京市公安局海淀分局備案號：11010802023656號